[s-cars] It was the plugs

[Walsh, Edward]

OK guys,

I swapped out the old NGK plugs for a set of minty F5DPOR.  Stumble/miss is
completely GONE!  It amazes me that an engine can be so picky about its
plugs.

While giving the Pearl avant a bath, I noticed that there are a few areas on
the bumpers where the clear coat is peeling.  Odd, its only on the bumpers.
Must be the result of flexing.  Anyway, what is the best way to have this
repaired?  Is there a DIY solution, or must I take it to a booth?

Another thing I noticed is that the CVs click at sharp steering angles at
parking lot speds.  No high speed noise or vibration, just the clicking at
low speeds.  Is it CV joint replacement time or can these be lubed?  If they
need to be replaced, is it a PITA job?

Thanks for all the help!

Ed (No, Paul, you can't laugh or poke fun, the car is still very schweet!)


--------------------------------------------------------------------------
Notice: Since e-mail messages sent between you and A.G. Edwards &
Sons, Inc. ("AGE") and its employees are transmitted over the
Internet, AGE cannot assure that such messages are secure. You
should be careful in transmitting information to AGE that you
consider confidential. If you are uncomfortable with such risks,
you may decide not to use e-mail to communicate with AGE. Although
you may be sending an e-mail message to a specific AGE employee,
other AGE employees may review such messages. Additionally, your
e-mail messages to AGE may, consistent with AGE's regulatory
requirements and retention policies, be retained. You should also
be aware that e-mail messages may be delayed or undelivered. AGE
does not accept orders to effect transactions or other similar
instructions through e-mail messages.
---------------------------------------------------------------------------