[s-cars] Auto check Brake pad warning

[UrS492 at aol.com]

--
[ Picked text/plain from multipart/alternative ]
In a message dated 6/6/02 4:38:15 PM Mountain Daylight Time,
panderso at maine.rr.com writes:


> I swapped out the front rotors and pads and plugged in the pad sensors.
> Everything seemed to have gone smoothly. However, my autocheck system
> doesn't seem to like my Mintex pads?  The low pad warning (O) is on.  Aside
> from checking my rear brakes which I will do right after dinner, is there
> another reason this could be happening -did I forget something?...and no, I
> don't yet have a Bentley.  I flushed out the fluid and it took about half a
> can as predicted by other listers (thank you).
>
>

Just went through this process,  same set up.  Mintex with slotted.  Bypass
the entire system and clip the wires from the brake pad.  Solder the contacts
together on the end.  I actually pulled up the rubber boot and did the
soldering in there and that is when mine finally went away.

Mark