[s-cars] Any tricks to installing Bilstein struts? and Intrax springs drop info

[Walsh, Edward]

Gary, thank you.
Well, one surprise is that Shox.com didn't send me the "tool" that you are
referring to.... Hopefully the install can be done w/o it.  Should I not put
the stock bump stock on the Bilsteins?
Thanks, Ed

------------
Should be no surprises. You could use a pipe wrench, but I took the little
tool supplied with the Bilsteins, cut a piece out of it so I could slide it
over the strut shaft, and then used a 1/2 drive ratchet wrench to tighten
the top cap. Note that the bump stop is internal. Gary 94 UrS4 91 200 TQA


--------------------------------------------------------------------------
Notice: Since e-mail messages sent between you and A.G. Edwards &
Sons, Inc. ("AGE") and its employees are transmitted over the
Internet, AGE cannot assure that such messages are secure. You
should be careful in transmitting information to AGE that you
consider confidential. If you are uncomfortable with such risks,
you may decide not to use e-mail to communicate with AGE. Although
you may be sending an e-mail message to a specific AGE employee,
other AGE employees may review such messages. Additionally, your
e-mail messages to AGE may, consistent with AGE's regulatory
requirements and retention policies, be retained. You should also
be aware that e-mail messages may be delayed or undelivered. AGE
does not accept orders to effect transactions or other similar
instructions through e-mail messages.
---------------------------------------------------------------------------