[s-cars] Re: How do coil overs adjust?
Huw Powell
human747 at attbi.com
Sun May 12 15:57:39 EDT 2002
> I am about to alter my coil over adjustment nuts for the first time and was
> searching the web for the best tool, and any BTDTs. One Miata site says
> that you wrench up the shaft to raise the height, and wrench down to lower.
>
> This is counter intuitive: if you raise the nut, you compress the spring,
> and the car should sit lower. Vice versa if you lower the nut.
>
> Where am I going wrong here?
Hmmm, well, I know virtually nothing about coil-overs, so ignore me...
but, if "raising" the nut *compresses* the spring, how is the spring
supporting the weight of the car? Wouldn't doing that raise the lower
spring perch and raise the car, since the spring compression should
remain the same, it is due to the amount of weight on it? (F ~ kx and
all that)
You can also just try it each way (raise/lower shaft) and once it's
obvious to you (on one corner?), set them all where you want, make a
note of the process, and post the results here!
just my barely $0.01...
--
Huw Powell
http://www.humanspeakers.com/
http://www.humanthoughts.org/
More information about the S-car-list
mailing list