[s-cars] ECS swap question

[FvAMI at aol.com]

--
[ Picked text/plain from multipart/alternative ]
In a message dated 9/30/02 11:20:44 AM Pacific Daylight Time,
jimk at spotgraphicsinc.com writes:


> Obviously
> it's not as good in either case, but will it actually cause problems?
>

I have run native ADU RS2 code (a little rich) and Lehman AAN RS2 with a K-24
 ... it runs fine. I would just keep the RPMs below 5500 under full throttle
to prevent over-spinning the turbo ... Native RS2 code does not have more
boost in the mid range than the MTM- 3 bar K-24, it may even be a little less
if my memory serves me correctly. I think the RS2 was limited to a maximum of
1.4 bar or 22.5 PSI ... the MTM software is closer to 24 PSI  in the mid
range and then tapered off at the higher RPM range to prevent over-spinning
the Turbo.

Best regards,
Feico van der Laan

Best regards,
Feico van der Laan