[s-cars] bolt to stud conversion?

[S4audinut at aol.com]

--
[ Picked text/plain from multipart/alternative ]
In a message dated 10/19/2002 1:37:51 PM Eastern Daylight Time,
lee at wheelman.com writes:

> I'm just wondering if now would be a good time to switch over to studs/nuts.
> That way I could run a single set of fasteners in the front and not have to
> worry about remembering which goes where...etc.
>
> Any thoughts on this? Bolts are a bit of a PITA, but not too bad. Any other
> pros/cons?
>
>

Understand that you will probably have to do wheel bearings etc, but when
done you will have the piece of mind you have done everything possible to
eliminate a potentially rough downside and that your wheels are as good as
can be. A locking lug nut or 2 will also bring some piece of mind. If you
derive them hard make sure they are up to the task.
Rod