[s-cars] dual mass flywheel

[QSHIPQ at aol.com]

--
[ Picked text/plain from multipart/alternative ]
How?  IMU with grinding, you use a magnet or other hold down device, and have
a stone do the work.  I suppose it could be done this way, but IMO you run
into the same problems you have with a chuck type, only in a different plane.

Not enough information here.  Typically, flywheel resurfacing is done on a
lathe.  Correct?  Depends.

SJ
In a message dated 9/25/02 2:29:04 AM Central Daylight Time,
nard1 at voyager.net writes:


Typically is it not the correct way to have the flywheel ground (grinded)? I
just did one today.
Best,
Tim Leonard
ESCARGO