[s-cars] Fwd: Re: CLUTCH- Throwout bearing guide sleeve

[brian bilotti]

--

Note: forwarded message attached.


__________________________________________________
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo
http://search.yahoo.com
--
Date: Thu, 24 Apr 2003 21:28:31 -0700 (PDT)
From: brian bilotti <vinnieb2 at yahoo.com>
Subject: Re: CLUTCH- Throwout bearing guide sleeve
To: Audi20V_Kruemmer at yahoogroups.com
In-Reply-To: <b8aamv+8rlv at eGroups.com>

Gentlemen:
My local shop installed a Spec Clutch recently and
there aparently wasn't a sleeve for the throwout
bearing on the last clutch so it was assumed one
wasn't needed. Welll, the motor needed to come out
last week(don't ask)and that poor little doughnut
throwout bearing was shot. The shop owner didn't like
the way it fit but had nothing to compare it to so he
put it in the same as the previous shop had, some of
you know who that is,. Ok, fast forward, I look in the
family album and I see 2 part #'s, one for a CRB,
which I have, and one for a five speed, I think. I'm
looking at illustration 141-10. This is the A10Q
model. The RS2 page only illustrates the lower pic.
So, I guess the question is, are these 2 parts
interchangeable or do I need a CRB guide sleeve?
I welcome any wisdom and light from this respected
therapy group.

later
Brian Bilotti
'93 S4 "Edwin"


__________________________________________________
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo
http://search.yahoo.com