[s-cars] Fwd: Re: CLUTCH- Throwout bearing guide sleeve

QSHIPQ at aol.com QSHIPQ at aol.com
Sat Apr 26 09:06:22 EDT 2003


--
[ Picked text/plain from multipart/alternative ]
Brian:
I used the same for both, as it calls for in the family album 01E141181A.
I'm assuming this is a 5spd AAN01E to 6spd ADUCRB conversion?  If so, both
are 01E based transmissions, and both use the same TOB and TOB sleeve.  The
N/A 5 cyl and the 4 cylinder use the 012 number listed in the 100Q pages.

The way the FA works is that pix applying to the car will show PN (and in the
case of the 010Q, both the N/A and the turbo clutch assbly's are valid), try
to click on it when N/A (as in the RS2 pages), you get "PN unknown" flag.

HTH

Scott Justusson


In a message dated 4/24/2003 11:45:12 PM Central Daylight Time,
vinnieb2 at yahoo.com writes:

Date: Thu, 24 Apr 2003 21:28:31 -0700 (PDT)
From: brian bilotti <vinnieb2 at yahoo.com>
Subject: Re: CLUTCH- Throwout bearing guide sleeve
To: Audi20V_Kruemmer at yahoogroups.com
In-Reply-To: <b8aamv+8rlv at eGroups.com>

Gentlemen:
My local shop installed a Spec Clutch recently and
there aparently wasn't a sleeve for the throwout
bearing on the last clutch so it was assumed one
wasn't needed. Welll, the motor needed to come out
last week(don't ask)and that poor little doughnut
throwout bearing was shot. The shop owner didn't like
the way it fit but had nothing to compare it to so he
put it in the same as the previous shop had, some of
you know who that is,. Ok, fast forward, I look in the
family album and I see 2 part #'s, one for a CRB,
which I have, and one for a five speed, I think. I'm
looking at illustration 141-10. This is the A10Q
model. The RS2 page only illustrates the lower pic.
So, I guess the question is, are these 2 parts
interchangeable or do I need a CRB guide sleeve?
I welcome any wisdom and light from this respected
therapy group.

later
Brian Bilotti
'93 S4 "Edwin"




More information about the S-car-list mailing list