[s-cars] front bumper cover removal

[Lewis, Gary M]

Yes yes yes!!!!!!!

I can verify that this works like a charm, 2 weeks ago!!  All those pesky lower valence grills pop out perfectly as well.

The wife(tm) did it (cough cough).  Good thing I magically appeared to pick up all the crap that flew off...

Nice thing is that the bumper is ready for FMIC modeling.

And when you find a good epoxy, lemme know, will ya'?

Gary Lewis

1995.5 S6 Avant, Green/Ecru, RS2 MAF, RS2 Exhaust Manifold, RS2 Injectors, Custom Turbo (K26 Turbine, Factory K26 Cold side (Audi Works '999' P/N) with 50mm intake and custom Innovative Turbo compressor wheel), Bilsteins, Eibachs, Big Reds, Spec II Clutch.



> -----Original Message-----
> From: Lee Levitt [mailto:lee at wheelman.com] 
> Sent: Tuesday, December 09, 2003 9:44 AM
> To: thomas.pollock at amd.com; s-car-list at audifans.com
> Subject: RE: [s-cars] front bumper cover removal
> 
> 
> Tom writes:
> 
> >
> > Hi again....
> >
> > Can someone instruct me on how to get the front bumper cover off ?  
> > Also, anyone recomend an epoxy or other to repair a split ?
> 
> Usually, the way its done is to pull forward over a slightly 
> too high curb and then back up.
> 
> Also, it's *always* the wife or girlfriend that does it, 
> never a lister :)
> 
> Lee
> 
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com 
> http://www.audifans.com/mailman/listinfo/s-> car-list
>