[s-cars] Stromung, worth it?
Peter Schulz
peschulz at cisco.com
Mon Jan 20 09:06:16 EST 2003
Rod:
Can you further comment on the "not mandrel bent"...
Did Norman take short sections of bends and weld them together?
Or do the pipes have that "corrugated"' look?
-Peter
>Guys, Norman of fantasy fabricarionsb in concord NH built me one out of mild
>steel and it is the finest setup I have ever seen on any car. Looks better
>than some of the 2000$ systems I have seen. I use no cat, a dynaflow center
>and a new stainless rear muffler from Thermo tec. I got the thermo tec for
>349$ (the finest piece I have ever seen and all parts are replaceable with
>any size in or out single in dual out any combo of sizes. I have a total of
>850 $ in this and it includes everything. It was not mandrel bent. You can
>get really good value from a good shop and the right components. This is a
>very high flow system yet is not boomy and sounds aggresive at full chat but
>not loud around town. Every car is different and to me the ultimate setup is
>tailored to your car. That said the Stromun? systems are pertty good but IMO
>a bit pricey if you have a local craftsman.
>Rod
>_______________________________________________
>S-CAR-List mailing list
>S-CAR-List at audifans.com
>http://www.audifans.com/mailman/listinfo/s-car-list
Peter Schulz
1990 CQ
1991 200 20v TQW indigo mica
1991 200 20v TQW titanium grey
Chelmsford, MA USA
peschulz at cisco.com
More information about the S-car-list
mailing list