[s-cars] Transmision parts flywheels

[Bob Rossato]

Have you tried the usual aftermarket places, like The Parts Connection, GPR,
Adirondack, etc?  Years ago when I was rebuilding a VW 020 gearbox I was
able to get bearings and synchros from GPR (http://www.gprparts.com/).  They
might be able to get gears as well.

Bob

> -----Original Message-----
> From: s-car-list-bounces at audifans.com
> [mailto:s-car-list-bounces at audifans.com]On Behalf Of Tim Leonard
> Sent: Sunday, November 23, 2003 8:52 PM
> To: Charlie Smith
> Cc: Audi S Car List
> Subject: Re: [s-cars] Transmision parts flywheels
>
>
> Charlie,
> GOOD USED is ok. Although for synchronizers I will opt for new. I was
> looking for a source of the OEM internals other than dealer. I
> know of many
> parts on Audi's that are available from aftermarket suppliers
> that are made
> by the OEM supplier, this is what I meant but obviously was not clear.
> Besides all synchro's I need 01E 311 239 H 1,2 synchro hub, which
> originally
> was 01E 311 255C as stamped on the 1,2 synchro hub in the trans. FA also
> says 01E 311 239E can be used. Also need
> 01E 311 529A reverse gear and synchro, 016 311 839D. Problem with
> the trans
> was difficult/stiff shifting. First gear is fine. Synchro hub and rev gear
> have the points knocked off their teeth. They may be fine to use
> but as long
> as I'm here I felt I may as well replace if not too pricey. Any advice? I
> know you have researched these trans extensively. Have you actually torn
> down too? The clutch and pressure plate have already been
> purchased. "Stock"
> Sachs kit. I want a flywheel these parts will bolt up to without spending
> for the OEM dual mass @ $810. Perhaps I should be asking for a good used
> dual mass? This one will rotate as measured at the outside edge approx 1"
> before becoming "one". Where do the transmission rebuilders
> (assuming there
> is such a person/business) source their parts needs? The dealer?
> I doubt it.
> Best,
> Tim
>
> > Earlier, Tim Leonard wrote:
> > >
> > > I am looking for aftermarket 01E transmission internals and a flywheel
> for a
> > > '92 S4. Anyone?
> >
> > I have never heard of anyone making "aftermarket" 01E transmission
> > internals.  Now, there's several options on flywheels and clutches
> > but I can't lay them out for you.  Son\mebody else needs to say
> > stuff on this one.
> >
> > Now USED 01E internals, that you can find.  What do you need?
> >
> >     - Charlie
> >
>
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
>