[s-cars] camber link removal problem

[Paul Gailus]

I used a Facom U.17 ball joint separator tool to remove the
rear upper link. It fit perfectly and the joint popped off easily
(at least mine did).

It's a little pricey at $60 from the Ultimate Garage:
http://www.ultimategarage.com/facauto.html

However, it's very well made and has all the telltale
signs of being drop forged.

Paul


----- Original Message -----
From: Konstantin Bogach <kbogach at comcast.net>
To: <s-car-list at audifans.com>
Sent: Sunday, September 28, 2003 10:17 PM
Subject: [s-cars] camber link removal problem


> Hi folks.
> I am loosing fight with rear camer link on my S4'93.  Apparently,  UrS4
> has different geometry where ball joint is fixed to the body because
> pittman arm puller I use on 5K does not fit there.  I totaled 2 ball
> joint removal tools already.  They were not fit up to this job.  The one
> I brought from Russia turned out to be a joke also, to my surprise, even
> though it looked  very powerful.   Besides that I tried BFH to no avail
> (with old nut covering tip of the thread)
> Any advise will be appreciated.  Inclulding Audi tool part number, as
> last resort, of course.
>
> Thanks.
> Konstantin.
> Hightstow, NJ
> UrS4 '93
> 200tq '89
> 200tqa '89
>
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list