[s-cars] Installing Strut Tower Cross Brace on '92 S4?

[Mark Strangways]

I have a 93' CAD S4 which has both the strut brace and the extendable hood
shock.
I have no interference problems with it at all.
Perhaps you are putting it on wrong ?
It goes to the rear of the strut towers, and covers the POS and wring cover.

Mark S

I can take a picture of mine if you need me to.
----- Original Message -----
From: <henryb at aciworldwide.com>
To: <s-car-list at audifans.com>
Sent: Monday, September 29, 2003 11:11 AM
Subject: [s-cars] Installing Strut Tower Cross Brace on '92 S4?


> This is a multipart message in MIME format.
> --
> [ Picked text/plain from multipart/alternative ]
> I have picked up all of the parts to install a strut tower cross brace on
> my '92 S4 - which did not come with one installed from the factory.
> However, now that I have the brackets and the bar... I have found that the
> reason these bars were not installed on the '92's was that the
> "extendable" hood lifter is right in the way of the drivers side bracket.
>
> The only way that I could see too solve this problem, would be to move the
> mounting position of the hood lifter where it attaches to the fender.  Has
> anyone BTDT?  And is there an adapter bracket out there that will move the
> lifter to a position that allows the brace to fit?
>
> Brent.
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list