RS2 EM Studs, was RE: [s-cars] Right angle drill I could borrow (CT area)?

[Sean Douglas]

The N 906 486 01 should be the p/n for the 27 mm stud. It's a
european-spec part and is not available through the regular dealer
channels. The standard leangth stud is 35 mm and has an unthreaded
portion (shank) in the middle. I do not know if the RS2 studs are
supposed to have a shank or if you have a generic 8 mm stud.

The OEM studs have a slightly different thread for the part that threads
into the head, its flattened and "locks" into the aluminum head. Also,
the OEM stud has a chamfered end about 3mm long with no threads on it to
allow starting the nut easier.

The measurements of 27 or 35 mm is measured from the unthreaded shank to
the end of thread and does not include the chamfered end or the part
that threads into the head.

Sean Douglas
1997 Audi S6//RS2-spec
1990 Audi 90 quattro 20v


> -----Original Message-----
> From: Marc Swanson [mailto:mswanson at sonitrol.net] 
> Sent: Thursday, July 15, 2004 5:35 AM
> To: Sean Douglas
> Cc: s-car-list at audifans.com
> Subject: RE: [s-cars] Right angle drill I could borrow (CT area)?
> 
> 
> 
> > right parts based on the listing on s-cars.org, which shows PN N... 
> > (net down, fill in here..)
> 
> 
> Ahem.. forgot to proofread my message..
> 
> I bought PN N 906 486 01
> 
> And they have no non-threaded section like the stock EM studs 
> (which is what I meant by 'shoulder'.
> 
> Thanks
> 
> -- 
> -Marc Swanson-
> 95.5 //S6 Avant
> 87 4ktq
> 88 90q
> www.mswanson.com/audi
> 
>