[s-cars] alignment issue with lowered s4 '93

[kbogach at comcast.net]

PO installed Eibach/Bilstein Sport setup and made same shop to  modify 
camber plates per Igor's spec.   Having known that I did not pay much 
attention  to tires until I noticed metal cord sticking from worn out 
inner edge.   I  found that the  left plate is accurate Igor's spec but 
the right one is not.   In fact it has larger effective offset from OEM 
spec than Igor's spec (4 mm).  Both tires have worn out edge.  The rest 
of tire is almost like new.
 I  am going to measure camber and try to set it to correct value  on 
Satruday using  a tool described by Igor in his post (key part is an 
electronic level).   I have a couple questions :
1.  What is correct camber values if my preference is even wearing 
(rather than better conering).
2.  For those who did Igor's mod:   did you get satisfactory results? 
    Group buy for 2B camber plates ends on Monday.   

Thanks a lot.
Konstantin.