[s-cars] GP to construct a new timing belt cover

[Emre Washburn]

So who all would be in on this? I'll make some calls today if there is any
interest shown.

Emre
----- Original Message ----- 
From: "James Murray (QB/EMC)" <james.murray at ericsson.com>
To: <s-car-list at audifans.com>
Sent: Tuesday, May 18, 2004 10:38 AM
Subject: [s-cars] GP to construct a new timing belt cover


> There, just had to change the subject heading... ;-)
>
> ----- Original Message ----- 
> From: "James Murray (QB/EMC)" <james.murray at ericsson.com>
> To: "'Bill Clancy'" <clancybill at yahoo.com>; "'Dave Forgie'"
> <forgied at direct.ca>; "Mark Strangways" <strangconst at rogers.com>
> Cc: <s-car-list at audifans.com>
> Sent: Tuesday, May 18, 2004 7:30 AM
> Subject: RE: WAS Re: [s-cars] Died on I4, now no-start, NOW timing belt co
> ver
>
>
> > Bill, we are talking about have a new Timing Belt (TB) cover built to
> replace the current plastic one, so that if the serpentine belt snaps as
it
> has happened in the past to a few listers, the broken seprentine belt will
> not break the TB cover and also damage the timing belt resulting in engine
> damage! Preventive measure only...
> >
> > Dave and Mark and talking about having one made from aluminum, Emre and
I
> think a Carbon/Kevlar mix is a more economical way to go...
> >
> > Hope that makes sense?
> >
> > Cheers, /James.
> >
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
>