[s-cars] C4 chassis remote lock help

[Larry C Leung]

The car is a 95.5. And it's definitely RF remote. There is no "sensor" on
the 
driver's (US) B-pillar.

LL - NY

On Tue, 18 May 2004 07:52:08 -0400 "Tom Mullane" <tmullane at snet.net>
writes:
> Franco,
> 
> That sounds like the procedure for the IR keys.  What  year is your 
> car?
> 
> Tom
> ----- Original Message ----- 
> From: "Franco Barber" <feb at febsun.cmhnet.org>
> To: "Larry C Leung" <l.leung at juno.com>
> Cc: <tmullane at snet.net>; <quattro at audifans.com>; 
> <s-car-list at audifans.com>
> Sent: Tuesday, May 18, 2004 1:37 AM
> Subject: Re: [s-cars] C4 chassis remote lock help
> 
> 
> > On Mon, May 17, 2004 at 11:51:44PM -0400, Larry C Leung wrote:
> > > Bummer. Didn't work. Holding down both buttons on the remote for 
> 15
> > > seconds did
> > > nothing. Is there any history of the remotes failing? I checked 
> the
> > > voltage on the new
> > > battery (I know, not under load) and it was at 3.26 V. Any 
> other
> > > suggestions?
> >
> > Larry,
> > Try this procedure:
> >
> > 1.Open the driver's door.
> > 2.Take one key and turn on the ignition.
> > 3.Close the driver's door.
> > 4.Lock the car with a second key.
> >
> > 5a. On the remote control you want to program as "remote 1",
> >     press the Open button exactly one time.
> > 5b. Wait 6 seconds.
> > 5c. On the same remote control, push the Open button exactly one
> >     more time.
> >
> > 6.If steps 5a-c worked, the lights may flash and the car will 
> unlock.
> > 7.Open the driver's door.
> > 8.Remove the key from the ignition.
> >
> > Now you can test the remote by locking the door with it.
> >
> > Notes:
> > 1) If you want to program multiple remotes, the additional
> >    remotes get more than one button press in step 5a.
> >    "Remote 2" gets two presses at one second intervals, etc.
> > 2) At most 4 presses are valid.
> >    If you press 5 times, it erases all the stored remote 
> controls.
> > 3) Important: Note step 5c; after the final
> >    (1st, 2nd, 3rd, 4th or 5th)press,
> >    you have to press again after 6 seconds.
> > 4) The manual says that the car will beep after each press, but I 
> have
> >    seen some cars where it does not beep, and you have to go on 
> blind.
> > 5) The manual implies that after this procedure is performed then 
> Remote 1
> >    will be assigned to seat memory 1.  I am not sure about this 
> bit at
> all.
> >    I think you may have to go through the key to seat memory 
> assignment
> >    procedure after you've done the remote procedure.
> >
> >
> > Franco
> >
> > <rest of post trimmed>
> >
> > -- 
> > Franco Barber                   feb at febsun.cmhnet.org
> > 95 A6Q w/Gamma CD mit RDS!      Columbus, Ohio  USA
> > 95 A6Q 5spd w/HCB-30 bluetooth car kit!
> >
> 
> 
> 
>