[s-cars] Alignment Specs w/Eibach Springs and Bilstein Shocks

[Tony]

Ken,

I had mine done with Bilstein/Eibach setup back in July. Check out archives
around the 10th July as there was plenty of dicussion on this subject. Also
I had a pair of 13mm spacers set under the rear spring perches. There was
some discussion about the back end sagging. My front and back measure evenly
between floor and top of wheel arch. The results of my camber alignment was:

Before
Left -1.1 deg, Right -2.0 degs.

After
Left -1.3 degs, Right -1.5 degs.

And Fred Munro posted this:

The official UrS4/S6 front alignment specs from page T44-4 of the Bentley
are as follows:

Toe: spec +15' (+0.25 degrees), range +5' to +20' (+0.08 degrees to + 0.33
degrees)

Camber: spec -50' (- 0.8 degrees), range -15' to -80' (- 0.25 degrees
to -1.33 degrees)
Note: Max difference between sides 30' (0.5 degrees)

Caster: spec +55' (+ 0.91 degrees), range +15' to +95' (+ 0.25 degrees to
+1.58 degrees)
Note: max 1 degree

Tony
96 S6


----- Original Message ----- 
From: "Ken Chang" <audi94s4 at yahoo.com>
To: <s-car-list at audifans.com>
Sent: Tuesday, November 30, 2004 9:15 AM
Subject: [s-cars] Alignment Specs w/Eibach Springs and Bilstein Shocks


> Does anyone know the alignment specs for a moddified
> setup?  Thanks
> Ken
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
>