[s-cars] Re: S-CAR-List Digest, Vol 11, Issue 38

[l.leung at juno.com]

Mike, 

Go to www.danielsternlighting.com to learn of how to 
optically adjust your lamps, rather than using the 
bubble. I found that according to the bubble, my lamps
are aimed WAY high, even though I have mine set for a 
low cut-off (worried about fog in the valley). You should 
have really excellent lighting with 9012's in your projectors. 
Mine's quite good (I haven't cleaned, nor relayed either)and as
I said, I set my on the low side, partially to cut below fog 
(until I get my fogs working with P-lights switch up), and
partially so that NO ONE has a reason to flash me. Set up by
Daniel Stern's directions and there'd be little need for 
high beams....

LL - NY



Message: 9
Date: Mon, 13 Sep 2004 07:43:20 -0700 (PDT)
From: Mike Claire <mclaire_us at yahoo.com>
Subject: [s-cars] Headlight adjustments
To: s-car-list at audifans.com
Message-ID: <20040913144320.82356.qmail at web40410.mail.yahoo.com>
Content-Type: text/plain; charset=us-ascii

My low beams are dangerously poor - even after
installing 9012s.

I know that the inside can be dirty and I need to
check that.  The lens itself isn't too sandbasted.

I also need to check the voltage to see if there's a
drop.

But I noticed for the first time that there's a bubble
level in the assembly.  What should this read?  Mine
is set to -1.  The cutoff is way too close and this
must be the reason why.  How do you make the
adjustment?


Thanks
Mike