[s-cars] Annoying headlight out indicator after HID install

[Sean Douglas]

All you have to do is bypass the wiring feeding the light control module
(LCM). This disables the low beam warning, but still maintains the
autocheck for the tail and brake lights.

The LCM is located in the relay box under the hood by the driver's side
firewall. It's a double-wide relay, remove it and pull up on the relay
holder to give you some working room. Cut the wires close the terminals
shown in the wiring diagram and use an insulated butt connector to join.
This effectively bypasses the LCM and voila, no more warning.

I documented it on a wiring diagram here;

http://pictureposter.audiworld.com/52091/lcm_modified2.jpg


Sean Douglas
1997 Audi S6//RS2-spec
1990 Audi 90 quattro 20v


> -----Original Message-----
> From: s-car-list-bounces at audifans.com 
> [mailto:s-car-list-bounces at audifans.com] On Behalf Of Elvis Palombizio
> Sent: Monday, April 18, 2005 8:34 AM
> To: s-car-list at audifans.com
> Subject: [s-cars] Annoying headlight out indicator after HID install
> 
> 
> Good Morning All,
>     Do I have to install a resistor inline to avoid
> seeing this headlight out warning after upgrading to
> HIDs for my low beams?
> 
> any btdts?
> 
> thanks in advance!
> 
> E
> 
> ------------------------------------------
> Elvis V. Palombizio, MCSE/A
> Mobile: 860.202.9226 _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com 
> http://www.audifans.com/mailman/listinfo/s-> car-list
>