[s-cars] Coil Rebuild ~ in line fuses

[bill mahoney]

Paul Galius wrote this some time ago WRT in line fuses,,Presumably 10amp?...
 "Another alternative to consider would be
to put the fuseholder block above the driver side footwell,
since you should have access there to the switched 12V
"circuit 15" from the ignition switch (black wire).
You would have to route the 5 wires from the fuses
into the engine compartment through a firewall grommet,
or through the "aux relay panel #1" under the hood.

Perhaps the easiest (but least elegant) solution would
be to put individual in-line fuseholders in each of the
wires under the hood. Preferably these would be of the
marine type to handle the exposure, and be placed away
from the heat of the exhaust system."

Yes I have BTDT WRT shorted coil to ground flat bed ride.
Paul ws a big help in saving what surely would have been big dealer
dough as was uncle bob in diagnosing the issue.
I think Paul did a subsequent complete write up but I could not find that one.
HTH
Bill M