[s-cars] Cruise Control - Big Hammer Approach

[calvinlc@earthlink.net]

Wish mine were that easy.  Mine passes all Bentley tests and still has a
problem.  I have tried 3 different cruise units and none of them fixed it.
--Calvin


-----Original Message-----
From: s-car-list-bounces at audifans.com
[mailto:s-car-list-bounces at audifans.com]On Behalf Of tim rad
Sent: Tuesday, August 23, 2005 6:43 PM
To: Jason Mawhinney
Cc: S-CAR-List at audifans.com
Subject: Re: [s-cars] Cruise Control - Big Hammer Approach


Do I need a new turn signal / cruise control switch?

Here is the results of my tests based on Bentlety's recommendations
1 Test Vacuum lines for leaks - pass

The following tests are run on the pins on the control module wiring
harness.
A Test for power when cruise switched on between (pins 8 - 5) - pass
B Test for ohms when cruise switch moved to resume (pins 8 - 10) - pass
C Test for ohms when cruise set switch pushed (pins 8 - 4) - fail replace
switch
D Test for ohms On Switch and brake pedal vent valve (pins 11 - 5) -
fail replace switch or vent valve
E Test for ohms brake pedal vent valve (pins 11 - 5) - fail replace
brake pedal vent valve
F Test vacuum pump - pump runs fine
G Test vacuum pump vent valve - valve clicks fine

After doing the test, I went for a test drive, and as expected, the
cruise was dead for about 5 minutes, then it started working.
Returning home and restesting still had the same things failing.....
Has anyone replaced this switch?  Do I need to pull the transmission
to replace this switch?? <grin>

regards
Tim

On 8/23/05, tim rad <tr0910 at gmail.com> wrote:
> Thanks all, my symptoms are intermittent cancelling of the cruiseafter
> 10-30 minutes of successful working, and failure to set at all (no
> comforting click from the passenger side kick panel).  I'll check your
> ideas and see if they work.
>
> It sounds like noone has gone the aftermarket route yet....
>
> On 8/23/05, Jason Mawhinney <jmawhinney at skybest.com> wrote:
> > What Jim says is true.  As well, check that the actual CC switch is
working.
> > I've had many problems with older Audi signal stalks involving the
cruise.
> > My now sold 4kq had a signal stalk out of a 90q20v and the cruise would
only
> > work if the stalk was on the high beam setting.  It would also cancel if
the
> > turn signal was used.  My 5ktq also occationally cancel the cruise if
the
> > turn signals were used.  I have also had these switches completely fail
so
> > the cruise doesn't work at all.  I haven't had any problems with the
S6's
> > cruise as of yet but I've only had it about a month!
> > Good luck,
> > Jason
> >
> >
> > ----- Original Message -----
> > From: "Pasqualoni James E" <james.pasqualoni at gs.com>
> > To: "'tim rad'" <tr0910 at gmail.com>; <s-car-list at audifans.com>
> > Sent: Tuesday, August 23, 2005 8:33 AM
> > Subject: Re: [s-cars] Cruise Control - Big Hammer Approach
> >
> >
> > > On Tuesday, August 23, 2005 8:09 AM, tim rad wrote:
> > >
> > > I need to fix my cruise control problems and noting others
frustrations
> > > with
> > > the Audi cruise, wondered if anyone had given up and just installed an
> > > aftermarket cruise like the following from JC Whitney?
> > >
> > >
http://www.jcwhitney.com/autoparts/ItemBrowse/c-10101/s-10101/p-100000216803
> > > /mediaCode-ZX/appId-10351479/Pr-p_CATENTRY_ID:10000021680310351479
> > >
> > > -----------------------------------------------------
> > >
> > > Wow, sounds like an expensive and time-consuming job to install an
> > > aftermarket unit.  Have you adjusted and/or checked your kick-out
switches
> > > for continuity?  In my experience, it is these units that usually fall
out
> > > of adjustment and/or fail.  Very inexpensive and easy fix if they are
the
> > > root of your problem.
> > >
> > > Jim
_______________________________________________
S-CAR-List mailing list
S-CAR-List at audifans.com
http://www.audifans.com/mailman/listinfo/s-car-list