[s-cars] Brake wear sensor question

[Gabriel Caldwell]

If shorting the two pins on the car side of the connector would not work
and the other side of the car is fine then you have a break in the
wiring harness and you'll have to cut and short it farther upstream.  My
break was right where the wires entered the engine bay.

Gabriel Caldwell


-----Original Message-----
From: Ivan Demkovitch [mailto:idemkovitch at hotmail.com] 
Sent: May 30, 2005 4:26 PM
To: s-car-list at audifans.com
Subject: [s-cars] Brake wear sensor question

Hi!

Have brake lining symbol illuminating on OBD. Looking at FL caliper I
see
disconnected broken connector going to sensor and taped connector going
from
"car" side.
Well.. I don't really care about that sensor (where do I get it from??)
but
I need to turn off that light. Not sure, but afraid they might turn me
around at safety inspection.

I see 3 pin "mother" connector and 2 of the pins seem to be having
copper in
it :) Shortening them together would not remove light.

Any ideas?

Also, I read somewhere Audi has 1 brake sensor. Is it true or there is
another one on a back like in my BMW?

Thanks,
Ivan
S4 93'

-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.322 / Virus Database: 267.2.0 - Release Date: 5/27/2005
 
_______________________________________________
S-CAR-List mailing list
S-CAR-List at audifans.com
http://www.audifans.com/mailman/listinfo/s-car-list