[s-cars] Motor mount R/R

[Young, Steve]

Listers...

I know this should be a straight forward project, but I have run up against
a stumbling block.  Caveat...I have not given this the attention I should
before bothering the collective knowledge base, so an obvious "d'oh" may be
lurking.
I decided to replace the motor mounts since I had so much of the engine
compartment clear while doing an RS2 upgrade, and I figured the originals
were still on the car @ 140K. I started with the passenger side first. I
can't seem to raise the motor enough (about 2 threads short of clearing) for
the top stud on the motor mount to drop enough and clear the bracket for
removal. Not enough room to tilt the mount in any direction to clear either.
It appears that maybe I need to loosen both motor mounts and raise the motor
straight, instead of trying to tip it to one side?? Any words of wisdom?? 
I get to certain height, and then the whole chassis starts to raise. I
figured I might be out of lateral twist when jacking from one side only.  Do
I need to remove the snub mount?
I searched Audifans FAQ, Charlie Smith's site, and S-Cars.org.  Is there a
write-up out there I missed?
TIA...from the bonehead, I'm not usually this thick, S-head in NY

Regards,

				TRANE
Steven Young
Local Operations Manager
Albany Office
*  Tel. (518) 724-1453
* Fax (518) 785-4359
* sryoung at trane.com

The contents of this e-mail and any attachments to it contain confidential
and/or legally privileged information, which is only for the use of the
intended recipient.  If you have received this e-mail in error, please
notify the sender by return e-mail immediately.

Furthermore, if you are not the intended recipient, you are hereby notified
that any disclosure, copying, distribution, or the taking of any action in
reliance on the comments or the contained information included herein or
attached hereto is strictly prohibited and that the documents should be
returned to the sender immediately.