[s-cars] Inner CV Joint R&R?
Sean Douglas
quattro20v at telus.net
Mon Nov 27 23:10:26 EST 2006
Yes, the boot will slip off over the outer end (if the outer joint is off).
The inner joints are a PITA to get off, and usually requires a press. You
can probably clean it enough and repack using the above method.
Regards,
Sean
> -----Original Message-----
> From: s-car-list-bounces at audifans.com [mailto:s-car-list-
> bounces at audifans.com] On Behalf Of Mark Pollan
> Sent: November 27, 2006 9:29 AM
> To: s-car-list at audifans.com
> Subject: [s-cars] Inner CV Joint R&R?
>
> G'day:
>
>
>
> I have both of my front halfshafts out to replace the leaky output flange
> seals. I plan on cleaning, re-packing and replacing the outer boots while
> the shafts are in hand. The grease in the inner joints is kinda "crusty"
> so
> I am probably going to R&R those joints/boots as well. R&Ring the outers
> has been pretty well documented but I cannot scare anything up on the
> inners. Anybody have a write-up and/or can offer some guidance? I am
> thinking to slip the inner boot off while the outer joint is off rather
> than
> also removing the inner joint. Do you think I will be able to
> sufficiently
> clean/dry the inner joint with it on the shaft? Any secrets to installing
> the flange seals while I am asking a bazillion questions?
>
>
>
> Regards,
>
>
>
> Mark
>
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list
More information about the S-CAR-List
mailing list