[s-cars] Help on 2B camber plates install

Steve Marinello smarinello at entouch.net
Tue Dec 11 15:20:54 PST 2007


Guys,

Finally getting around to installing these beauties...but it won't quite 
work.  There doesn't seem to be enough threaded shaft to get the nut on 
the strut completely.  Removing the lower strut cap/sheath gives a 
couple of threads, but to get it tightened up the way it should, I can't 
use any upper washer, and 2B did supply one for that purpose.  The 
instructions do say remove lower and upper washers on the car, but I 
can't see going without any upper washer at the nut.

Experience on this?  The struts are supposed to be Bilstein Sports that 
were part of the Abt/Eibach/Bilstein set-up the PO put on the car.   
They appear to have no more than 1 1/2" of thread; can't remember 
whether that's right, as it's been too long since I wrenched shocks into 
the departed S6 sedan.

Glad I finally got around to this anyway.  He had the stock plates 
slotted to where there's maybe an eighth of an inch left at the edge...

Thanks in advance,

Steve


More information about the S-CAR-List mailing list