[s-cars] Tap size needed for waste gate screw?

[Young, Steve]

Dave...

The screw is steel and the cap is aluminum.  Will backing out the screw
clean up the threads?


Regards,

Steven Young
Local Operations Manager - Albany
____________________________________TRANE
301 Old Niskayuna Rd., Latham, NY  12110
Tel: 518.724.1453
Fax: 518.785.4359

www.trane.com

The information in this message is the property of TRANE. This message
is intended only for the use of the addressee named above and may
contain legally privileged and/or confidential information.  If you are
not the intended recipient of this message, you are hereby notified that
any use, dissemination, distribution or copying of this message is
strictly prohibited.  If you receive this message in error, please
notify us immediately by telephone or return e-mail and delete the
message, all copies thereof and any attachments. We thank you for your
cooperation.


-----Original Message-----
From: s-car-list-bounces at audifans.com
[mailto:s-car-list-bounces at audifans.com] On Behalf Of Dave Ellis
Sent: Tuesday, June 17, 2008 8:36 AM
To: s-car-list
Subject: [s-cars] Tap size needed for waste gate screw?


Went to back off the wastegate screw yesterday and noticed that the top
threads are damaged, likely from whenever the cover plate was drilled
off.

Does anyone know the size of tap needed to to re-tap the waste gate?

Thanks!

Dave
_______________________________________________
S-CAR-List mailing list
S-CAR-List at audifans.com
http://www.audifans.com/mailman/listinfo/s-car-list