[s-cars] Tie rod end removal

Fred Munro munrof at sympatico.ca
Sat Nov 1 12:52:49 PDT 2008


Paul;

It's been a while since I replaced tie rod ends, but from what I recall
there is a conical sleeve that the nut forces against the tie rod end to
compress it and lock it to the tie rod . Just loosening the nut leaves the
sleeve in place and the tie rod end locked - you have to knock the conical
sleeve back with a punch to release the rod end.

As I said, it's been a while, but I hope this helps.

Fred Munro
'97 S6


-----Original Message-----
From: s-car-list-bounces at audifans.com
[mailto:s-car-list-bounces at audifans.com]On Behalf Of Paul Heneghan
Sent: November 1, 2008 2:52 PM
To: S-Car-List (E-mail)
Subject: [s-cars] Tie rod end removal


Help!

I'm trying to replace both front tie rod ends on my wife's 1995 S6.  I've
started with the right-hand side and I'm having problems separating the tie
rod end from the tie rod. The 22mm locknut and the clamping ring were very
easy to loosen.  But, now I can't get the tie rod end off.  I've tried
penetrating fluid, I've tried a plumber's blow torch, I've tried rotating it
clockwise, I've tried rotating it anticlockwise, but it won't budge.

Should I remove the whole tie rod so I can get better access to it and use
bigger wrenches?

Any BTDTs?

Paul
_______________________________________________
S-CAR-List mailing list
S-CAR-List at audifans.com
http://www.audifans.com/mailman/listinfo/s-car-list



More information about the S-CAR-List mailing list