[s-cars] Re;[s-ars] Oil Leak - Driver's side of engine
Tom Green
trgreen at comcast.net
Tue Aug 18 13:53:01 PDT 2009
Most probably buy the aftermarket parts online since the switch is
used on a wide variety
of models, just matching the black insulator for the pressure range -
that is listed as 1.4 bar
and those that reference an OEM number post 068 919 081.
By the time the light comes on, the engine is out of oil, so your
reaction is late already.
I think most old school types would prefer a pressure gage, the issues
are where to put it
and the pressure switch works fine as long as the center insulator
doesn't blow out. If a
similar failure happened to a gage sender, I don't think you would
gain any reaction time,
so a gage is not a certain cure for this problem.
Tom
> On Tuesday 18 August 2009 Jack Walker
> <jack at walkerperformancegroup.com> wrote:
> Date: Tue, 18 Aug 2009 09:57:48 -0700
> From: "Jack Walker" <jack at walkerperformancegroup.com>
> Subject: Re: [s-cars] Oil Leak - Driver's Side of Engine
> To: <s-car-list at audifans.com>
> Message-ID: <33D334E5D4774678AB26721BE3A1DC34 at NOTEBOOK>
> Content-Type: text/plain; charset="us-ascii"
>
> So by the time an oil pressure light comes I'm assuming the oil is
> so low
> that you better make a decision to stop that baby from spinning
> right away!
> Replacement of the sensor sounds simple when doing an oil change. I
> didn't
> seen the sensor part number in any of the posts?
>
> Does the sensor have the capacity to split in multiple directions as
> in
> continue onto the oil pressure light and a pressure gauge as well or
> does
> the collective wisdom of the group recommend getting a pressure
> gauge tapped
> into somewhere else or eliminate the light? Frankly I'd prefer just
> eliminating the light and go with a stand alone electrical/
> mechanical gauge,
> but I'm sure the Audi gods wouldn't allow that ; ^)
>
> Jack
More information about the S-CAR-List
mailing list