[s-cars] hose to steering rack and brake fluid reservoir connector

[Peter Golledge]

I've used "near flat" box before as I recall (too many Audis and now too many wrenches!)

As I recall the Brake reservoir sensor/connector is reed switch.  When I damaged mine I sourced a replacement from another reservoir I had lying around. If you have a junkyard with some Audis around I'm pretty sure you could find a match.

Not sure if these are common over multiple cars and I don't have Etka handy right now. :-)


On 10/31/2010 8:43 PM, Konstantine Bogach wrote:
>    Just tried to quickly undo high pressure hose to steering rack, at
> almost 10 pm, outside... and failed.  I guess the right wrench is
> straight box one.   Am I right?  I had only 30 deg offset.  Socket seems
> does not fit there.
>
> The brake fluid level connector is "conveniently" located in the area
> and I cracked it.  This is the male one which comes out of the
> reservoir.   It was very brittle from time.  Do I need to buy new
> reservoir or the  connector is plugged into the reservoir.  ETKA shows
> it as a separate part (893 611 377 A), but maybe not, as it appears in
> two place on the illustration and one might mean that it comes only with
> reservoir.
>
> Thank you.
> Konstantine
> UrS4 '93
>
>
> _______________________________________________
> S-CAR-List mailing list
> http://audifans.com/mailman/listinfo/s-car-list
> http://www.audifans.com/kb/List_information
>