[s-cars] Heater not working

[Steve Mills]

Actually, the 2x2 connector is in the under-hood relay/fuse panel on the driver's side. Only the very early 92 S4s had an additional set in the console, and those were for the airbag controller, not the CC head. 

On Oct 25, 2010, at 7:22 AM, "JC" <jc at j2c3.com> wrote:

> Heh heh I knew about KL lines but not the KY lines.  I guess I would have
> expected the KY lines to be in the trunk.
> 
> Badumpbum.   Thanks I'll be here all week.
> 
> Anyway, just to be clear since I'm not sure JR has covered the basics - the
> CC codes can be pulled either from a VAG-COM connected to the bus (under the
> hood in the relay box), or even easier, pulled straight from the CC head
> itself using internal diag routine, aka no VAG-COM needed...
> 
> Why golly geezum I think there might be a FAQ that can help out...
> http://forums.quattroworld.com/s4s6/msgs/47427.phtml
> 
> VAG-COM (oh sorry, <-- insert whatever new legaleaze they've had to rename
> it to...) is "nicer" for code pulling but can't beat the on-board
> easy-access of the built in CC head...
> 
>> 
>> The K-Y connectors for VAG-COM are behind the HVAC head  - I
>> have been told this but never used them myself.
>> 
>> Tony
>> 96 S6
>> 
> 
> 
> __________ Information from ESET NOD32 Antivirus, version of virus signature
> database 5561 (20101025) __________
> 
> The message was checked by ESET NOD32 Antivirus.
> 
> http://www.eset.com
> 
> 
> 
> _______________________________________________
> S-CAR-List mailing list
> http://audifans.com/mailman/listinfo/s-car-list
> http://www.audifans.com/kb/List_information