[s-cars] Borescope'ing the oil pick-up

[djdawson2 at aol.com]

 No doubt your experience may have been different, but I got mine out just pulling the front bolts.

Back to the original issue... what makes you think your pickup might have issues?

 


 

 

-----Original Message-----
From: brian hoeft <qweblog at gmail.com>
To: djdawson2 at aol.com
Cc: fastscirocco_2000 at yahoo.com; s-car-list at audifans.com
Sent: Thu, Sep 16, 2010 10:49 am
Subject: Re: [s-cars] Borescope'ing the oil pick-up


Not saying remove the control arms, but break the bolts free & drop down along with the 2 front and 2 rear sub-frame bolts.

I thought the CA bolts went through the sub, into the body. I dont remember getting enough play out of just dropping the front like you suggest. Or maybe I was uncomfortable with the stress I was putting what remained attached.

Whatever the case, I do remember trying to be minimal about removing the oil pan and it turning into more than just two front sub bolts to get it out.

-Brian





On Thu, Sep 16, 2010 at 12:27 AM,  <djdawson2 at aol.com> wrote:

 I never said anything about removing your control arms...

Seriously, you can get the oil pan out by just dropping the front of the subframe... no need to touch the control arm points.  BTDT...

 


 

 


-----Original Message-----
From: brian hoeft <qweblog at gmail.com>



To: djdawson2 at aol.com
Cc: fastscirocco_2000 at yahoo.com; s-car-list at audifans.com
Sent: Wed, Sep 15, 2010 8:41 pm
Subject: Re: [s-cars] Borescope'ing the oil pick-up


I know, but I just replaced the control arms and im a hardware freak. "Always replace" may not mean always, as I remember you speaking to before, but my policy is to replace them every other time and they've all been re-torqued once..

-Brian




On Wed, Sep 15, 2010 at 10:32 PM,  <djdawson2 at aol.com> wrote:

 If you've got that sort of concern, I'd just drop the oil pan... it isn't that rough.



 


 

 

-----Original Message-----
From: chris chambers <fastscirocco_2000 at yahoo.com>
To: brian hoeft <qweblog at gmail.com>; liSt <s-car-list at audifans.com>
Sent: Wed, Sep 15, 2010 8:07 pm
Subject: Re: [s-cars] Borescope'ing the oil pick-up


Brian,

17-3 of the AAN engine manual shows the pick up in illustration 17-303, looks to 

be in the front to me.
Here is a link where you can download the manual in pdf format.

http://s2-audi.co.uk/workshop/aan/aan.pdf

HTH
Chris

 

________________________________
From: brian hoeft <qweblog at gmail.com>
To: liSt <s-car-list at audifans.com>
Sent: Wed, September 15, 2010 9:58:13 PM
Subject: [s-cars] Borescope'ing the oil pick-up

Hi list,

I am concerned that I may have a contaminated engine oil pick-up screen.

Wondering if anyone has had any success using a borescope in the oil pan.

I forget, but ithought the AAN pick-up is in the front of the pan, but
forget if the baffles, however minimal, or dimensions make using a borescope
for this task even possible, going in through the drain plug hole.

A colleague of mine has a snap-on borescope with fancy lighting effects, but
if it cant even contort into place, whats the point.

Just typing to know if theres any BTDT for this scenario.

thanks, Brian




-- 
http://208.53.138.125:8068/
[blinders off&earplugs out]
_______________________________________________
S-CAR-List mailing list
http://audifans.com/mailman/listinfo/s-car-list
http://www.audifans.com/kb/List_information



      
_______________________________________________
S-CAR-List mailing list
http://audifans.com/mailman/listinfo/s-car-list
http://www.audifans.com/kb/List_information

 





-- 
http://208.53.138.125:8068/
 [blinders off&earplugs out]

 





-- 
http://208.53.138.125:8068/
 [blinders off&earplugs out]