[s-cars] Oil Line Adapters

[Peter Golledge]

I upgraded a 200TQ to an aftermarket earls cooler with adapters, my local Hydraulic shop had them in stock.  I recall they were M18 but I don't have the car any more to measure.  I put the cooler on the passenger side and "louvered" the wheel well liner to get better airflow.  Best upgrade for this car to keep things cool!

Weatherford makes some nice "screw into place" AN fittings to mate onto heavy duty hydraulic hose.


On 9/15/2011 7:12 PM, Tony Curran wrote:
> Hi All,
>
>
>
> I'm looking to replace my oil cooler with an after market unit. This will
> entail replacing the oil lines from the filter bracket. The oil lines bolt
> to the bracket via two adapters (unions in Audi speak). ETKA illustration
> 115-60 identifies the union as part no. 034 117 233 B but does not identify
> the size.
>
>
>
> Question is, does anyone know the size of the adapter? I'll be using an AN-6
> fitting on the hose so need (I'm assuming) a metric thread to AN-6 adapter.
> EKTA gives a clue in that the seal is A18x24 (N 013 816 5). Is it safe to
> assume this seal is a M18 size?
>
>
>
> 034 has this part that maybe just what I need.
>
>
>
> http://www.034motorsport.com/hardware-fittings-hoses-an-npt-and-adapter-fitt
> ings-18mm-to-adapter-fitting-p-19226.html
>
>
>
> Anyone else done this?
>
>
>
> Thanks,
>
>
>
> Tony
>
> 96 S6
>
> _______________________________________________
> S-CAR-List mailing list
> http://audifans.com/mailman/listinfo/s-car-list
> http://www.audifans.com/kb/List_information
>