[s-cars] UrS4 strut insert tool
Peter Golledge
petergolledge at gmail.com
Tue Jun 5 20:11:06 PDT 2012
If the same as 5000 / 200 it is 34mm. I have Dennis G's fine setup which
is a large nuts welded onto each end of a length of pipe. Looks like
imperial size nuts ground down wee bit. I recall using this on my 95 S6
but I might be dreaming...
Peter Golledge
On Jun 5, 2012 7:12 PM, "Duncan Thomson" <thomson.duncan at gmail.com> wrote:
> Hi guys,
>
> Looking to install my new konis in the S4, and have found details for
> replacing the inserts without removing the strut. Just need to machine up a
> removal tool.
>
> Does anyone have dimensions for the hex cutout in the top of the strut cap?
>
> If not, I can probably measure and test fit in place, just gathering info
> at this stage..!
>
> Cheers
> Duncan
> _______________________________________________
> S-CAR-List mailing list
> http://audifans.com/mailman/listinfo/s-car-list
> http://www.audifans.com/kb/List_information
>
More information about the S-CAR-List
mailing list