[s-cars] Bueller? Bueller?

[David Forgie]

Paul: You have a G40 cam sensor that is going out/dieing.  Time to replace it before it strands you.

G40 info:  http://forums.quattroworld.com/s4s6/msgs/22580.phtml

Specific G40 replacement DIY: http://picasaweb.google.com/persing/CamPositionSensorReplacement#

Buy the replacement from Marc S. at EFI Express. 

Good luck

Dave F.

----- Original Message -----
From: "Paul Luevano" <paul at clarity.net>
To: "David Forgie" <forgied at shaw.ca>
Sent: Tuesday, September 17, 2013 6:48:13 AM
Subject: Re: [s-cars] Bueller?  Bueller?

David Forgie wrote:
> Sept.16th and I don't see any posts yet? Huh?

	Ok, I'll see if I can get the list chatter up a bit.

	Patient, 1995.5 S6, ~206,000 miles.  I have been getting an 
intermittent CE light while driving.  The car has also been hard to 
start of 4-5 occasions in the last month or so.  The engine would crank 
over just fine, but it would never fire.   After cranking and letting 
sit for a minute or two, the engine would fire, and everything would be 
back to normal.

2113: (G40) Hall sensor in distributor
(3B, early AAN engines) or camshaft position Hall Effect sensor later 
S4/S6 AAN engine).
Distributor alignment, faulty sender, Mis-located sensor & distributor, 
Cam timing possibly incorrect on AAN engine, Check lower Crankshaft Gear 
keyway

Got that code twice.

	What's the next step?

	Thanks!

Paul Luevano
Wayland MA