[urq] turbo rebuilder -- Ned's thoughts

[Ned Ritchie]

Brandon,

The K24 uses a relatively thin shaft, and small bearings.  This is in
contrast to the RS2 K24 and the K26 found on the 5000 cars.

If you are attempting a larger cold side consider the 10mm shaft and
bearings instead of what you have on the K24 now.

Ned

-----Original Message-----
From: urq-bounces+q=intendedacceleration.com at audifans.com
[mailto:urq-bounces+q=intendedacceleration.com at audifans.com] On Behalf
Of Brandon Rogers
Sent: Tuesday, December 23, 2003 9:11 AM
To: urq at audifans.com
Subject: [urq] turbo rebuilder

Hi All-
I'm looking for recomendations on a good place to have a K24 rebuilt.  I
had one rebuilt by Majestic Turbo in TX with bad results (long story).
I also don't like TEC in Golden, CO.  

Are there any mods that can be done to a K24 to increase performance,
like clipping the impeller or something or another..???

I understand Garrett has better technolgy these days.  Is there a way to
bolt a Garrett cold side to KKK hot side and bearing.  It would be nice
to get _some_ better technology but be able to keep water and oil
fittings stock.  Just thinking.....these could be silly ideas...?

Brandon

_______________________________________________
Audifans urq mailing list
Send posts to: mailto:urq at audifans.com
Manage your list connection:
http://www.audifans.com/mailman/listinfo/urq
Have an Audi question?  Look for your answer in the Audifans
Knowledgebase!
http://www.audi-quattro.org/kb ... all contributions welcome!