[urq] Still ABS problem on Urq

[Ado Sigal]

Thanks Jim, thanks Phil; cleaned and reset the sensors again, just in case, 'chisel' side perfectly parallel as it was,
still same problem. Sensor clearance now is 1 mm, previous was 1.5 mm, and ABS noise that starts after initial
engagement, stays on now for longer than before, so there is a difference. BTW, what should be sensor-CV required
distance, and of course, any more ideas?

Regards,

Ado Sigal


Phil Payne wrote:
> 
> > Somewhere in the work you've done one or more of the sensors has been
> > disturbed and now the ABS unit isn't seeing the same level of signal from
> > each sensor.
> > Could also be due to dirt/dust/rust etc on the cv joint teeth.
> >
> > Sometimes simply resetting the sensors works, other times you have to clean
> > the cv joint teeth and reset the sensors. If the teeth are badly corroded
> > the it's time for new joints.
> 
> And the "chisel end" of the sensor must be parallel to the teeth on the hub - it's easy to
> twist it round on removal.
> 
> --
>   Phil Payne
>   http://www.isham-research.com
>   +44 7785 302 803
> 
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
> Have an Audi question?  Look for your answer in the Audifans Knowledgebase!
> http://www.audi-quattro.org/kb ... all contributions welcome!