[urq] RE: [Es2] consensus on clutch/pressure plate parts?

[Jack Walker]

Same question different engine and car: 1983 UrQ, AAN engine, stock
motor at first with RS2 exhaust and Intake, eventually totally RS2
equipted, stock UrQ tranny.
consensus on clutch/pressure plate parts/flywheel? Upgrades for the long
haul?

Have very many other guys actually completed this swap, Urq/AAN?
Can anyone put me touch with them.
Have a couple of questions on the radiator needed for the swap.
Some say a 3B oil pan is the only way to go. AAN hits the rad, Everyone
pretty much agrees on this
Others (2Bennett) say a Dialynx rad clears the oil pan, can use the
orginal AAN oil pan
Can I retank a new (last fall) coupe radiator
Either way I gotta get do something
Either for sale by anyone?

Anyone have for sale?
fuel rail to fit a RS2 IM?
3B/RR/ABY/ADU water manifold
RR(20V ur q) thermostat to heater pipe with outlet for after-run cooling
pump
RR turbo to IC hose
RR/ABY/ADU upper radiator hose
ADU pressure pipe
RR/ABY/ADU aux. coolant pump bracket

Any other list I should get in touch with conversions?

TIA

Jack Walker

Ivey Imaging
5679 SE International Way
Milwaukie, Oregon
97222
jwalker at ivey.com

www.ivey.com

503)353-6521 direct line
503)807-3807 celluar phone 



-----Original Message-----
From: es2-bounces at audifans.com [mailto:es2-bounces at audifans.com] On
Behalf Of Miller, Chris
Sent: Monday, April 26, 2004 5:41 AM
To: es2 at audifans.com
Subject: [Es2] consensus on clutch/pressure plate parts?

Anyone figure out the best parts to buy (and part numbers, prices,
etc.)?
3B engine, stock coupe tranny and flywheel.

---
Chris Miller
Training Development
[i] The Information Foundry at Robert Bentley, Inc.
Tel: 617.528.4113
Cell: 617.875.3792
mailto:chris.miller at infofoundry.com
http://www.infofoundry.com
_______________________________________________
Es2 mailing list
Es2 at audifans.com
http://www.audifans.com/mailman/listinfo/es2