[urq] Re: [s-cars] RE: H&R help

[Mark Strangways]

Now my memory is bad but......
Aren't the front springs MUCH larger in Diameter then the rears ?
Or have I just taken one to many hits off my crack pipe today

Mark
----- Original Message ----- 
From: "Bob Rossato" <bob.rossato at att.net>
To: <DGraber460 at aol.com>; <quattro at audifans.com>; <urq at audifans.com>;
<s-car-list at audifans.com>
Sent: Sunday, February 15, 2004 9:15 PM
Subject: [s-cars] RE: H&R help


> > Setting on the floor the H&Rs are 3" shorter than the stock. The
> > springs are
> > marked as "055" for front, and "100 VA" for the rear. The H&R web
> > site only lists
> > the kit # as 29545.
>
> I'm not familiar with Urq springs at all, but I'm just going to take a
wild
> shot here.  The "100 VA" you list for the rear may actually be the fronts.
> Often spring part numbers will include a "V" for "vorne" (German for
Front)
> and "H" for "hinter" (German for Rear).  So it's possible you have the
> springs swapped around, and since the rear springs are typically softer it
> would make sense that the front is too low.
>
> Bob
>
>
> _______________________________________________
> S-CAR-List mailing list
> S-CAR-List at audifans.com
> http://www.audifans.com/mailman/listinfo/s-car-list