[urq] S4 Brakes (G60 Girlings) onto the URQ
Mike Sylvester
msylvester at verizon.net
Thu Feb 19 12:34:29 EST 2004
'91 200q20v, V8 and S4/S6 rear calipers are all the same.
They can be used on the rear of the urq if you use the S4/S6 rear rotor and
the newer handbrake cables.
The dust shields will need some modification
Mike Sylvester
'83 urq w/ 200q rear calipers and S4 rotors
----- Original Message -----
From: "Jack Walker" <jwalker at ivey.com>
To: <urq at audifans.com>
Sent: Thursday, February 19, 2004 12:24 PM
Subject: [urq] S4 Brakes (G60 Girlings) onto the URQ
Perhaps I'm a little confused (as if if that could happen).
Are you planning on using the rear calipers on the front of your URQ? My
impression was, we use the fronts with the orginal URQ caliper bracket and a
5000 rotor on the fronts of our URQs. On the same issue is there a specific
year for the 5000s we should use? Just getting started and going to be doing
this soon and need the direction. Can we switch the rear S4 to the rear of
the URQ, as well. I know I have seen some mention to use the V8s rears on
the backs. Do either of these setups use the orginal one-piece handbrake
cable.
I have both the front and rear calipers from my 93 S4 donor car for my 20V
conversion I can use.
Jack Walker
Ivey Imaging
5679 SE International Way
Milwaukee, Oregon 97222
Direct Phone line 503)353-6521
jwalker at ivey.com
Martin,
I know some have recommended the "all in one" cube. I recommend for the
extra $40, from the toolwarehouse, the "proper" caliper kit. It will
include proper adapter for most Audis/VW's and other popular imports. While
the cube has its place, I tried it on pretty new Jetta calipers. As you may
know you have to turn while placing a good amount of pressure on the puck.
Good luck with this tool and a sticky caliper. (and what used calipers
aren't?) It is very difficult to get the required leverage with the cube,
though obviously others have who recommended it. Pay up andf you will have
a quality tool for many applications that is quicker/easier to use.
Mike
Message: 2
Date: Tue, 17 Feb 2004 22:45:10 EST
From: CARDCONSYS at aol.com
I have acquired a set of s4/S6/V8 rear Girling calipers to install
on
my 83 UrQ. Can anyone please tell me how the cylinders should be retracted,
for handbrake adjustment, as there are not the usual VW/Audi large hex key
recesses but only a pair of triangular 'notches' diametrically opposed on
the
circumference of the cylinders? Is there a recommended VW/Audi/Girling tool
or
do
I need to make my own?
Martin Dapot
_______________________________________________
Audifans urq mailing list
Send posts to: mailto:urq at audifans.com
Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
Have an urq question? Check the Audifans Knowledgebase!
http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
Have an urq answer? ... Please help others by adding to the KB ... all
contributions welcome!
More information about the urq
mailing list