[urq] Eibach Springs?? Help!

[DGraber460 at aol.com]

In a message dated 10/25/2004 10:36:40 AM Mountain Daylight Time,  
martin at quattro.ca writes:

http://www.quattro.ca/DSC03049.JPG

Guys, got a big  problem.
Installed a set of Eibach springs...
Part numbers  Front:
EW$1504001VA
Rear:
EW$1504002HA

Result is seen in  picture... the back end is way up and front is the same
way that the  H&Rs used to be (which I didn't like).

I did have a set of Eibachs  before and they made the car look very natural
(a bit higher in the front  and a wee bit of a squat in the back).
I frickin hate this HotRod look....  :(

Can someone verify the part numbers are for TYP85 quattro?? I should  have
done the P/N research prior to installation...  DOH!!!!

Thanks!!
Martin  Pajak

http://www.quattro.ca

1983 Audi Ur-quattro (305,000 km)  for sale : (
1985 Audi Ur-quattro (210,000 km) Euro spec. import mit 3B  ;o)
1971 Porsche 911T (45,000 mi) all  original


_______________________________________________
Audifans  urq mailing list
Send posts to: mailto:urq at audifans.com
Manage your list  connection: http://www.audifans.com/mailman/listinfo/urq
Have an urq  question?  Check the Audifans  Knowledgebase!
http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
Have  an urq answer? ... Please help others by adding to the KB ... all  
contributions welcome!



When I installed the Eibachs on my car I got them all on only to find  that I 
had them back to front. The front was WAY down (I'm talking low rider  here) 
and the rear was correspondingly too high. My numbers were 055 rear and  100VA 
front. That doesn't match any numbers you show, and your car doesn't look  as 
far off as mine did when they were switched. Your's looks like it is  setting 
higher than mine currently all around.
Puzzling!
Are you sure they are the right springs?
 
Dennis
Denver