[urq] Subframes bushings r&R procedure

[Bill Bennett]

The subframe cracks, I posted this a couple years back on two cars. One was
a URQ the other was VW Quantum wagon Syncro. both had aluminum front
crossmembers mounts, and both had cracked front subframes, and both had
broken in the same place, right front inboard about 7 inches from the right
front body mounting point, they were not cracked, they where separated,
split, broken, 5 mm gap. wanna break a front crossmember? add solid mounts
and you will. Bill
----- Original Message -----
From: "Tony Lum" <tlum at flash.net>
To: "Buchholz, Steven" <Steven.Buchholz at kla-tencor.com>; <urq at audifans.com>
Sent: Friday, September 24, 2004 6:34 PM
Subject: RE: [urq] Subframes bushings r&R procedure


> At 01:27 PM 9/24/2004 -0700, Buchholz, Steven wrote:
> >I seem to recall reading a report from Audidudi some years back that Al
> >bushings couple more vibration to the unibody of the car and can lead to
> >damaging the integrity of the unibody.  Does anyone else remember this
> >report?  I know that he was referring to a car that he was auto crossing
...
> >
> >
> >Steve B
> >San Jose, CA (USA)
>
> Yes I remember that post.  I think it referred to a FWD 4000 where cracks
> in the body developed.
>
>
> --
> Tony
>
> '80 5KS
> 83 urquattro #DA900302
> '85 4kq
> '87 5kcstq
> '87.5 coupe GT
>
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
> Have an urq question?  Check the Audifans Knowledgebase!
> http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
> Have an urq answer? ... Please help others by adding to the KB ... all
contributions welcome!
>