[urq] 84 urq no crank

[todd ward]

Hell-o, Well I seem to be throwing parts at my 84 urq
with a no crank problem. To date I've replaced or had
replaced:Ignition coil, wires,plugs,cap,rotor,Hall
sender, sensor under Hall sender, and had igntn cntrl
module checked along with ecu. The car was still
cutting out after I got it back from the shop, but
their inability to repair the problem led me to drive
it back to St. Louis {it ran fine on the highway}. We
then drove it again on a small errand, again it ran
fine other than rough starting. The next day hard
starting and it wouldn't catch. Hasn't started since
and wore out the starter trying to start it. Replaced
the starter and noticed the Rpm needle would
bounce{while the engine wouldn't crank} when trying to
start, sometimes clear to 7k. I was getting a spark
from coil to distributor. One maybe two sparks then
nothing when turned to crank but no cranking then two
more sparks when the key was released. Replaced
ignition switch and now I'm not recieving any spark at
all. I've cleaned all grounds checked fuses and am at
a loss. Scott at SJM suggested I try using a jumper at
the starter to connect battery connection to terminal
50 soleniod on the starter. Good thing its such an
easy reach especially since it won't start and isn't
on the ramps. Whew!!! I'm willing to try all
suggestions. Frustrated in the Lou Thanks Todd W.


		
__________________________________ 
Do you Yahoo!? 
Yahoo! Mail - Helps protect you from nasty viruses. 
http://promotions.yahoo.com/new_mail