[urq] Cruise control

[Buchholz, Steven]

... IME the factory switches already have compliant caps.  

I would recommend against adding anything here ... it is just something
else that might fall off and get wedged in somewhere that affects your
ability to operate the vehicle.  It is a very simple matter to remove
the electrical and vacuum connections to the switch and screw them in a
turn or two until they operate properly ... 

Steve B
San Jose, CA (USA)
> 
> Are you talking of the valves at the pedal cluster ?
> 
> If so, then I found a way to have them behave correctly: I just put
some
> silicone closet doors bumps on the tip of the plunger. That way, the
> natural resting position is further in (and with greater force), and
the
> valves are now leak free. Before, a small bump in the road was enough
to
> make the CC disconnect. Now, it doesn't unhook at each bump, and I
didn't
> had to remove the switches from the pedal cluster.