[urq] After-run coolant pump?

[Brandon Rogers]

Well I believe all the afterrun pumps are the same.  I bet you could buy the 
MC upper rad hose and and it would "bolt" right in.  You'd probably also 
need the MC coolant pipe that runs along the block to the heater core.  What 
I'm not sure about is how/where the MC puts the temp sender.  All I'm 
familiar with is the 3B- it has the dedicated afterrun temp sensor on the 
water manifold (which does not exist on the 10V engines...)  I guess a good 
look at the TFA would reveal the location of the parts....now when it comes 
to the wiring I'm as dumb as they come...

not sure if this helps at all.....

Brandon

----- Original Message ----- 
From: "Pasqualoni, James E" <james.pasqualoni at gs.com>
To: <urq at audifans.com>
Sent: Monday, June 06, 2005 6:54 AM
Subject: [urq] After-run coolant pump?


> Guys,
>
> Anyone out there using an after-run coolant pump on your WX/WR motor with
> water-jacketed turbo?  If so, which one might you recommend?  How best to
> wire (on after-run injector fan circuit, etc)?
>
> As always, TIA,
> Jim
>
> Mr. Bennett-I owe you an apology.  I referred to you as Bob in an earlier
> note.  Must've been those stooopid pills I've been taking again-sorry ;-)
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
> Have an urq question?  Check the Audifans Knowledgebase!
> http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/UrQuattro
> Have an urq answer? ... Please help others by adding to the KB ... all 
> contributions welcome!