[urq] Front end clunk

[Michele_Deltergo at KeyBank.com]

Not sure if it is the root cause yet, but pulled the "new" Bilstiens and
the bottom shaft is measurably smaller in Diameter than the stock Boge and
can certainly make a good case for the strut moving under load.  many have
commented on the intense tightened pressures needed on the collar to keep
these seated.  I am a bit surprised that they are not better mated size
wise for the application.  Will reinstall stock size and recheck for clunk.


Mike



*******************************************************************************
This communication may contain privileged and/or confidential information. It
is intended solely for the use of the addressee. If you are not the intended
recipient, you are strictly prohibited from disclosing, copying, distributing
or using any of this information. If you received this communication in error,
please contact the sender immediately and destroy the material in its entirety,
whether electronic or hard copy. This communication may contain nonpublic personal
information about consumers subject to the restrictions of the 
Gramm-Leach-Bliley Act. You may not directly or indirectly reuse or redisclose
such information for any purpose other than to provide the services for which
you are receiving the information.

127 Public Square, Cleveland, OH 44114
*******************************************************************************


If you prefer not to receive future e-mail offers for products or services from
Key send an e-mail to DNERequests at key.com with 'No Promotional E-mails' in the
SUBJECT line.