[urq] Front end clunk

[Michele_Deltergo at KeyBank.com]

We appear to have a winner!  Can't remember the who mentioned wheel bearing
slop, but that appears to be the case.  It makes sense in as much as it was
replaced before the noise appeared.  Apparently there was a TSB back in the
day (1987) but served up mostly for 4000Q where as a "slight metallic noise
could be heard when accelerating away from a stop especially when steering
hard in one direction and suspension under load"  This applied to the 75 mm
wheel bearing which was partially resolved with an "upgraded" bearing 443
498 625 and more permanently solved with a bigger 82 mm bearing and
housing.  The wrench (different from the installer) was very surprised at
the ease with which the bearing came out, very little force.  I now need
best source for above bearing and RF CV joint for same as it was damaged in
the diagnosis process.
thx

Mike



*******************************************************************************
This communication may contain privileged and/or confidential information. It
is intended solely for the use of the addressee. If you are not the intended
recipient, you are strictly prohibited from disclosing, copying, distributing
or using any of this information. If you received this communication in error,
please contact the sender immediately and destroy the material in its entirety,
whether electronic or hard copy. This communication may contain nonpublic personal
information about consumers subject to the restrictions of the 
Gramm-Leach-Bliley Act. You may not directly or indirectly reuse or redisclose
such information for any purpose other than to provide the services for which
you are receiving the information.

127 Public Square, Cleveland, OH 44114
*******************************************************************************


If you prefer not to receive future e-mail offers for products or services from
Key send an e-mail to DNERequests at key.com with 'No Promotional E-mails' in the
SUBJECT line.