[urq] 200q20v transmission into UrQ

[Martin Pajak]

Hi Nathan,

Sorry for not replying to your message, it simply got lost in my inbox.. :(

Anyhoo, the linkage to be used is from Ur-q, all you need to do is move the
small ball joint on the tranny to match the position of the original
transmission, you'll see it when you have the units side by side.
It's all predrilled and tapped for both setups so it's a 2min job.

Hope this helps.
Martin



> -----Original Message-----
> From: urq-bounces at audifans.com [mailto:urq-bounces at audifans.com] On Behalf
> Of n-engelbert at terrans.net
> Sent: August 31, 2007 3:35 PM
> To: urq at audifans.com
> Subject: [urq] 200q20v transmission into UrQ
> 
> OK, I'm in the process of putting my 200q20v transmission into my 3B'd UrQ
> project, and I've moved over the speedo drive gear, but I've got a
> question about the shift linkage.
> 
> The large shifter rod attached to the left side of the transmission on the
> 20v and the UrQ are different part numbers. Do I need to swap the rod from
> my UrQ's 016 over to the 20v transmission, or should the rod from the
> shifter of the the UrQ mate right up to the 20v transmission's current
> part?
> 
> Thanks!
> 
> Nathan Engelbert
> 83 UrQ DA900453
> 89 90q
> 91 200q20v (wrecked)
> 95 S6 avant
> 
> 
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
> Have an urq question?  Check the Audifans Knowledgebase!
> http://www.audifans.com/twiki/bin/view/Audi/UrQuattro
> Have an urq answer? ... Please help others by adding to the KB ... all
> contributions welcome!