[urq] Throttle Body Shaft Linkage swap

[Ado Sigal]

No BTDT, but in essence you are going to end up with shorter shaft with 
slot for TPS. Wouldn't be easier to cut and file the shaft to suit, than 
to remove butterfly and all that. Even if it fails, you can always do 
the swap. BTW, shaft is one piece, and 2 sunk in screws hold the 
butterfly. Must clean the shaft before removing, and adjust butterfly 
and Locktite the screws after the swap.

Ado


Ben Swann wrote:

>I am trying to swap the shaft and certain parts from the later MC-1 throttle
>body to an earlier WX (Ur Quattro) throttle body.  This is so I can use the
>later switch(actually TPS) from later models.  
>
> 
>
>ANY BTDT on removing the shaft?  Is the shaft one piece that goes all the way
>through or does it split somewhere? Any diagrams.
>
> 
>
>Ben
>
>  
>